26
Fig. 23: Start menu at the mobile device for inverter configuration
The MaxLinkApp establishes the communication with the inverter and downloads the data.
Data are displayed on the screen.
Inverter is not available at the App MaxLink
If connected inverters are not displayed on your mobile device, follow the steps below to
display the inverter data on MaxLink:
■
Make sure inverter is switched on
■
Make sure no other phone is currently connected to the inverter WiFi.
■
Stellen Sie sicher, dass kein weiteres mobiles Gerät mit dem Wechselrichter verbunden
ist.
■
Go to your phone’s “Setting --> WLAN” and select the inverter WiFi access point (the
SSID name shows the inverter serial number, the password is 12345678).
If you have observed all the above points, select the „Connect to inverter“ button in the Start
menu of the MaxLink app again to obtain a list of all available inverters.
7�3
Configuration of the inverter
See the following steps for the configuration of the inverter, e.g. national standards, power
factor, derated power:
1. Select in the lower left corner of the App MaxLink the buttonSetting” to get the selection
menu of the local device (see the following figure).
Summary of Contents for 10260200
Page 1: ...Instruction Manual SolarMax SHT series 50SHT 60SHT...
Page 4: ...4...
Page 39: ...39 en Notes...
