105
10.2.5 Blockings
Status message
Cause
Measure
External blocking
There is a 0% command
from MaxRemote (coming
from the grid operator).
None. Wait until the grid
operator suspends the
blocking of the inverter via
MaxRemote.
Program Firmware
The inverter firmware is
currently being updated.
The inverter automatically
resumes mains operation
once the firmware update
is complete.
11 Maintenance
SolarMax inverters are basically maintenance-free. However, in order to ensure perfect
operation over the course of several years, in addition to regular controls of the operating
and yield data via the inverter display or remote monitoring, we also recommend perform-
ing the simple maintenance work described below at regular intervals. The maintenance
intervals must be set keeping the ambient conditions in mind (especially exposure to
dust).
The following checks can be performed by the plant operator. If you discover problems
while performing these checks, contact the electrician in charge of maintenance or our
SolarMax Service Centre.
n
Functional check of the inverter using the graphics display
n
On-site check of visible traces of wear and tear (damage, rain, snow, rodents, etc.)
n
Cleaning and check of plant room
n
Cleaning the fan screens
12 Disposal
Please dispose of the inverter at the end of its service life in compliance with the disposal
regulations then valid where it is installed. You can also return the inverter at your own
cost for professional disposal to Sputnik Engineering (address as stated in chapter “Trou-
bleshooting”).
Summary of Contents for 10MT2
Page 59: ...118 en ...
