en
45
Setting
Description
Error
The "Isolation fault DC" fault message (MaxTalk: "DC isolation error (AC)")
is displayed. The Compact Station immediately disconnects from the
mains. The status signaling contact of the MCU closes.
Rated power output of the PV generator
If you have the MaxTalk service software, you can specify the rated power output of the
PV generator. This value will be used for yield calculations.
Parameter
Description
Unit
Pinst tot
Rated power output of the PV generator. "Pinst tot" is used
for calculation "Prel" (see Section 6.5) and the target yield
(display in the MaxWeb portal).
W
6.4
Displaying the configuration
The inverter configuration can be displayed in the "Configuration" menu of the graphics
display. The configuration depends on the selected country setting.
In the "Main menu", select the "Configuration" menu.
back to the main menu /
scroll parameter
Parameter
Description
Unit
Country
Country setting at the time of commissioning
-
f nominal
Mains nominal frequency
Hz
Vac nominal
Nominal mains voltage
V
Vac min 1
Minimum admissible mains voltage (first limit)
V
t Vac min 1
Release time for minimum admissible mains voltage
ms
Vac max 1
Maximum admissible mains voltage (first limit)
V
t Vac max 1
Release time for maximum admissible mains voltage
ms
Vac min 2
Minimum admissible mains voltage (second limit)
V
t Vac min 2
Release time for minimum admissible mains voltage
ms
Vac max 2
Maximum admissible mains voltage (second limit)
V
t Vac max 2
Release time for maximum admissible mains voltage
ms
