46
633 Setting the network parameters
Device address
In order to communicate via an RS485 or Ethernet interface, the inverter needs a unique
device address on the network.
1. In the "Main menu" select the "Network" menu.
2. Select the "Device address" parameter.
3. Configure the parameter:
Parameter
Description
Value range
Device address
Device address of inverter
1…249
Configuring the Ethernet interface
In addition to the device address, the following settings must be made to communicate
via Ethernet:
1. In the "Main menu" select the "Network" menu.
2. In the "IP mode", select the required setting:
Setting
Description
DHCP client
The inverter is a DHCP client and is connected to a network with
DHCP server (factory setting).
Static
The inverter is connected to a network with static IP addresses.
3. If appropriate, configure the following parameters. These settings are only required in
"Static" IP mode (see step 2):
Parameter
Description
Value range
IP
IP address
192.168.1.123*
Gateway
Gateway of inverter
192.168.1.1*
TCP port
TCP port of inverter
12345*
DNS1
Domain name server 1
192.168.1.1*
DNS2
Domain name server 2
192.168.1.1*
Netmask
Subnet mask
255.255.255.0*
* Factory settings
4. Check whether the indicator for the Ethernet connection appears on the graphics
display (see Section 7.1).
634 Configuring the status signaling contact
When the multi-function relay is used as status signaling contact, the operating mode and
the delay time can be configured.
