SolarPath SPBS3 Installation Instructions Manual Download

Page: 3 / 6

123 Town Square Pl., #333 Tel. +1.201.490.4499

Jersey City, NJ 07310 www.solarpathusa.com

There is one button on each side of the lamp. Press the
button to select the working mode for each side individually.

The lamp can be charged in any mode.

First press of the button is Sensor Mode.

Second press of the button is Constant Lighting Mode.

Third press of the button is off.

Sensor Mode:

Automatically turns on to full brightness (2000lm) when motion is detected in the range ≤ 26.24 ft and

then turns to weak brightness (300lm) in 20 seconds of no motion.

Constant Lighting Mode:

Automatically turns on at dusk and remains at 50% brightness (1000lm) until dawn or powers off.

Remarks:

Working mode

mode

Product dimensions

Summary of Contents for SPBS3

Page 1: ...1 123 Town Square Pl 333 Tel 1 201 490 4499 Jersey City NJ 07310 www solarpathusa com Solar bollards SPBS3 Installation instructions ...

Page 4: ...ill four holes of 0 39 inch width and 2 75 inch depth on the flat concrete ground picture 3 Insert the expansion screws into the holes and lock the expansion screws with Allen Wrench pictures 4 Put the lamp onto the metal bracket and align the four holes then lock the lamp and metal bracket with screws spring washers and gaskets pictures Installation s ...

Page 5: ...re present 2 Insert two spikes into the lawn with a space of 2 36 4 72 inches between them Picture 3 Use screws and gaskets to fix the metal bracket onto the surface of spikes Picture 4 Put the lamp onto the metal bracket and align the four holes then lock the lamp and metal bracket with screws spring washers and gaskets Picture ...

Page 6: ... screws on the side of the lamp and lift up the lamp see picture 2 Loosen the battery cover screw open the battery cover and replace the corresponding battery pack see picture 3 After replacing the battery lock the battery cover and install the lamp onto the metal bracket see picture Battery replacement ...