BK508
ULTRA FLAT SOLAR WATCH
3ATM
TIME AND DATE SETTING
Position 0: Normal running position
Position 1 : Setting of the date
•
Gently pull the crown to position 1 and turn it in clockwise direction to
set the date.
•
Push the crown to position 0 to confirm and complete the setting.
In order to change the date the next day, the date must be set
between 2 am and 8 pm.
Position 2 : Setting of the time
•
Pull the crown to position 2 and then turn in clockwise direction to set the time.
•
Push the crown back into position 0 to confirm and finish.
ADJUSTING THE BRACELET YOUR WATCH
•
Take a special tool or a small Swiss knife.
•
Locate the arrow on the clasp of the buckle and lift it in the direction of the arrow.
•
Move the buckle forward or backward until you get the desired and close with the
appropriate tool.
•
Take your watch to a watchmaker if you cannot do it.
POWER
The solar watch has a dual power supply:
- built-up silicon solar panel inside the dial,
- backup battery (1xSR626SW, 1,55V
).
The backup battery provides energy to the watch even without being exposed to the sun.
The change of the backup battery should be carried out for a variable period from 24 to 36 months when the
watch stops working in the absence of the sun.
WARNING
•
To ensure a waterproof seal, always make sure that the crown has been pushed back into the normal
operating position.
•
DO NOT USE the crown or any other buttons underwater or when the watch is wet.
•
To maintain the aesthetic appearance of your watch, avoid contact with perfumes, nail polish, varnish,
cosmetics, cleaning products, adhesives, and paint, as they can cause discoloration, deterioration and
damage.
•
To prevent any risk from perspiration, dust and humidity, regularly wipe your watch with a soft, dry cloth.
•
To ensure the longevity of your watch, please observe the following instructions: Do not attempt to open
the watch casing. The battery must be replaced by a qualified person.
•
To avoid damage, make sure you do not drop or hit it against hard surfaces.
WARNING: You should not dispose of this device with your household waste.A selective collection
system for this type of product is implemented by your local authorities. Please contact your local
authorities to find out how and where collection takes place. These restrictions apply because
electrical and electronic devices contain dangerous substances that have harmful effects on the
environment or on human health and must be recycled.
This symbol indicates that electrical and electronic devices are collected selectively. The symbol
shows a waste container crossed out with an X symbol.
Imported by PRODIS SAS, 1 rue de Rome, 93110 Rosny-sous-Bois, France/ Made in PRC
Marketed by EUROTOPS VERSAND GMBH D-40764 LANGENFELD, Germany
BEFORE USING: In order to start the watch, please remove the plastic stopper first, and
then push the crown against the watch.
English
