1 |
P a g e
ATTENTION
The Solatherm controller and water heater vessel must be installed by an
authorised person and the installation must comply with all the relevant Australian
Standards, local and industry regulations.
ATTENTION
This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning use of the appliance by a
person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance
WARNING
Once installed the hot water tank is powered by TWO SOURCES of Power Supply,
both sources must be isolated before working on the appliance.
Before commencement of any service work on the hot water circuit,
including work that partially or completely drains the storage vessel,
ensure all electrical supplies, the Photovoltaic array and AC connection
have been disconnected as per the System Shutdown procedure in this
manual.
PV ARRAY WARNING
When the photovoltaic array is exposed to light, it supplies a d.c. voltage to the PCE.
WARNING
The controller is only to be connected to a hot water cylinder specifically designed
and configured for use with the Solatherm DC controller (P.C.E.). It is not for retrofit.
WARNING
If the equipment is used in a manner not specified by the manufacturer, the
protection provided by the equipment may be impaired.
CONNECTION
WARNING
Solatherm Photo Voltaic Over Temperature Cut Out (PVOTC) must be installed in
the power supply feed to the DC heating element.
WARNING
DANGER the operation of the PV (DC) thermal cut out indicates a possibly
dangerous situation. The water heater must be inspected by a qualified person and
the PV-OTC (PV thermal cut out) replaced.
