REAR PANEL
1.
AC MAINS INPUT - Connect to a grounded outlet in accordance with the voltage and frequency
specified on the rear panel of the amplifier.
Use only the factory supplied cord or a UL approved equivalent type.
2.
MAINS FUSE - Protects the amplifier from further damage in case of an electrical fault.
Warning! Replace only with same fuse type and rating.
3.
HT FUSE-HT is the high voltage fuse that protects the amp in case of a power tube failure. If this
fuse blows, most likely a power tube has failed.
Warning! Replace only with same fuse type and rating.
4.
LINE OUT- Line level taken from the power amp output, not the preamp.
5.
LINE OUT LEVEL- Adjusts the level of the LINE OUT.
6.
SPEAKERS - Two parallel speaker jacks.
7.
IMPEDANCE SWITCH - Set this switch to match the total impedance of you speaker(s).
8.
EFFECTS LOOP SEND JACK - Use a high-quality shielded guitar cable to connect to the input of
your effects unit.
9.
EFFECTS LOOP RETURN JACK - Use a high-quality shielded guitar cable to connect from the
output of your effects unit to the return of the amp.
10.
FOOTSWITCH: Single button foot switch for CHANNEL select (NORMAL or OVERDRIVE)
Summary of Contents for SLO-30
Page 1: ......