3
/
3
SAFETY INSTRUCTION
The manufacturer assumes no liability for uses other than those described in the operating instructions or for unauthorized
alterations.
The operating instructions and cautions should be read carefully and kept in an easily visible location in the vicinity of the
control system. Non-observance of the cautions will result in accidents, injury or risks to health.
CAUTION
1.
The power cord only can be inserted in approved power sockets or adapters.
2.
Automatic Blowing Function
Please note that the SMD rework system will automatically blow air after following operations to cool down. The power switch
of the SMD rework system should be switched to “OFF” position if you want to stop the SMD rework system. This action will stop
in about one minute (Do not disconnect the plug during cooling.). And then switch off the tool and disconnect the plug.
3
High Temperature
The temperature of the soldering tip or the nozzle will reach as high as around 400
℃
( 752
℉
）
when the power switch is on.
Since mishandling may lead to burn and fire, be sure to comply with the following precautions:
Do not touch metallic parts near the soldering tip/ nozzle.
Do not use this system near the flammable items.
Advise other people in the work area that the unit can reach a very high temperature and should be considered potentially
dangerous.
Turn off the power switch while taking breaks and when finishing using.
Before replacing parts or storing the system, turn off the power and let it cool down to the room temperature.
4
Take care of your tools
Do not use the tools for any applications other than soldering or desoldering.
Do not rap the iron/gun against the work bench or otherwise subject the iron to severe shocks.
Do not file the soldering tip to remove the oxide, please wipe the tip on the cleaning sponge.
Use only accessories or attachments which are listed in the operation manual. Use of other tools and other accessories can lead
to a danger of injury.
Please turn off the power before connecting or disconnecting the soldering iron.
ATTENTION:
While soldering iron heating is in progress ("HEAT" or "WAIT" shown on the display), it is forbidden to press any button on the
station. When soldering iron is powered up from cold state, a temperature overshoot may occur. This is a normal process and it
speeds up heating of the tip.
WARNING:
Please check before transport of the station if the four screws for fastening of the diaphragm pump are screwed. Screws are
situated at the bottom of the station. Without the screws the pump may get loose during transport and cause damage of other
components of the station. Warranty does not cover problems caused by not following the above instructions.
1.
Maintenance
Before further use, safety devices or slightly damaged parts must be carefully checked for error-free and intended operation.
Inspect moving parts for error-free operation and that they don’t bind, or whether any parts are damaged. Damaged safety
devices and parts must be repaired or replaced by a qualified technician, so long as nothing else is indicated in the operation
manual. Use only accessories or attachments which are listed in the operation manual. Use of other tools and other accessories
can lead to a danger of injury.
2.
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or
lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a
person responsible for their safety Young children should be supervised to ensure that they do not play with the appliance.
3.
Protect yourself against electrical shocks
Avoid touching grounded parts with your body, e.g. pipes, heating radiators and so on. The grip of antistatic designed soldering
tool is conductive.
4.
Work environment
Do not use the soldering tool in a moist or wet environment. The soldering iron and the hot air gun should be placed on the
holder after finished using.
Summary of Contents for SP-1011DLR
Page 1: ...1 3 SP 1011DLR...
