2. IMPORTANT SAFETY INFORMATION
• When using electrical appliances basic safety precautions should always be followed.
• Check that the voltage indicated on the rating plate corresponds with that of the local network before
connecting the appliance to the mains power supply.
• This appliance is not intended for use by persons (including children) with reduced physical, sensory
or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person responsible for their safety.
• Do not leave the station unattended while it is switched on.
• Do not use in an explosive atmosphere or around flammable materials.
• Do not expose to rain or moisture.
• Never place the product or part of it in water, or operate if your hands are wet.
• Never touch the heater pipe or allow for the heated air to blow against your skin.
• Do not disassemble the product.
• Make sure the power switch is in the “off” position and disconnect the plug when the unit is not in use.
• When attaching the nozzle, do not press the nozzle or pull on the edge of the nozzle using pliers and be
sure not to over tighten the screw.
• The power will automatically be turned off when the unit exceeds a certain temperature.
• Once the temperature has dropped off to a safe level, the power will automatically be turned back on.
3. Features
Hot air SMD rework station
Accurate & stable control on temperature
Auto-standby function, energy saving
Quick heating up
Automatic cooling system
Soft air flow and super low noise during operation
4. Specifications
Power - 300W
Voltage - 220-240Vac 50Hz
Temperature - 100-500℃
Display - LED
