• Press the button ”+ UP” or ”- DOWN” to adjust the temperature.
In short press, the set-point will change ±1℃.
In long press, the set-point will change quickly and reach your target temperature.
• ”℃/ °F” is the transfer button between ℃/ °F.
The default unit is ℃, press the ”℃/ °F” button to change between ℃ and °F.
7. Maintenance
Before further use, safety devices or slightly damaged parts must be carefully checked for error-free and
intended operation. Inspect moving parts for error-free operation and that they don’t bind, or whether any
parts are damaged. Damaged safety devices and parts must be repaired or replaced by a qualified tech-
nician, so long as nothing else is indicated in the operation manual. Use only accessories or attachments
which are dedicated for this device. Use of other tools and other accessories can lead to a danger of injury.
8. Caution
The power cord only can be inserted in approved power sockets or adapters.
High Temperature
The temperature of the soldering tip will reach as high as around 480℃ (896°F) when the power is on.
Since mishandling may lead to burn or fire, be sure to comply with the following precautions:
• Do not touch metallic parts near the soldering tip/ nozzle.
• Do not use this system near the flammable items.
• Advise other people in the work area that the unit can reach a very high temperature and should be
considered potentially dangerous.
• Turn off the power switch while taking breaks and when finishing using.
• Before replacing parts or storing the system, turn off the power and let it cool down to the room temper-
ature.
• Warning: this tool must be placed on its stand when not in use.
• A fire may result if the appliance is not used with care, therefore
----be careful when using the appliance in places where there are combustible material;
----do not apply to the same place for a long time;
----do not use in presence of an explosive atmosphere;
----be aware heat may be conducted to combustible materials that out of sight;
----place the appliance on its stand after use and allow it to cool down before storage;
----do not leave the appliance unattended when it is switched on.
Take care of your tools
Do not use the tools for any applications other than soldering or desoldering.
