10
E20
/
E25
ELLIPTICAL
1. Attach front (
89
) and rear (
90
) Handle Bar Covers together on left Swing Arm
shaft, and secure using two Sheet Metal Screws (
122
) and the Phillips Head
Screw Driver (
150
). Repeat this process on the right side with Handle Bar
Covers (
91
) and (
92
).
2. Install Console Mast Covers (L & R) (
81
&
82
) on each side of the Side Cases
and secure with two Sheet Metal Screws (
122
) and the Phillips Head Screw
Driver (
150
).
3. Secure left Slide Wheel Cover (
87
) on left Pedal Arm with two Phillips Head
Screws (
120
) and the Phillips Head Screw Driver (
150
). Repeat this process for
the right Slide Wheel Cover (
88
).
4. Snap Rear Bar Cover (
97
) into the hole on the Incline Rail Assembly.
PLASTIC
PARTS
4
HARDWARE
STEP 4
1. Connect the Upper Swing Arm (L) (
18
) to the left Lower Swing Arm and
connect the Upper Swing Arm (R) (
19
) to the right Lower Swing Arm , and
secure them with six Hex Head Bolts (
106
), four Curved Washers (
143
) and six
Nyloc Nuts (
129
) by using the Wrenches (
151
&
152
).
UPPER
SWING
ARMS
3
HARDWARE
STEP 3
See Page 11 for Illustration
See Page 11 for Illustration
#106
. 5/16” x 1-3/4”
Hex Head Bolt (6 pcs)
#129
. 5/16” x 7T
Nyloc Nut (6 pcs)
#143
. 5/16” x 23mm
x 1.5T Curved Washer
(4 pcs)
E20
ASSEMBLY INSTRUCTIONS
#120
. M5 x 15mm
Phillips Head Screw
(4 pcs)
#122
. Ø3.5 x 12mm
Sheet Metal Screw
(6 pcs)
Summary of Contents for E20
