Dyaco Canada Inc
.2013
-8-
F60 ASSEM
BLY I
NSTRUCTIONS
ASSEMBLY
STEP 1
1. Remove the treadmill from the carton and position it aside on a smooth, level
floor.The rear should be at least 3’from any wall.Do not remove the Velcro
belt until you have rmoved the plastic wrap and styrofoam from beneath
the unit.
Turning the unit on its side after removing the belt may cause
the unit fold up and cause serious injury!
ASSEMBLY
STEP 2
1. Connect
Computer
Cable
(Upper/Lower)(
44
)with Computer Cable(Middle)
(
43
)then Insert RiGHT AND Left Uprights(
4
) and(
5
)into the Frame Base(
2
)
And use the Wrench(
100
)to tighten eight Hex Head Bolts(
97
)and eight Flat
Washers(
76
)
Before attaching the hardware to Step 3, make sure the cables you just connected don’t
get pinched in between the steel tubing. If they do, this may cause issues that prevent
the treadmill from operating properly.
1
2
43
44
4
5
97
97
97
97
76
76
76
76
97
97
76
76
97
97
76
76
100
2
#76.
Ø5/16" × Ø18 × 1.5T
Flat Washer (8 pcs)
#97.
5/16" × 1/2”
Hex Head Bolt (8 pcs)
HARDWARE
STEP 2