29
CALIBRATION PROCEDURE
1. Remove the
Safety Key
.
2. Press and hold down the
Start
and
Speed
buttons and replace the
Safety Key
. Continue
to hold the
Start
and
Speed
key until the window displays “Factory settings”, then press
the
Enter
key.
3. You will now be able to set the display to show Metric or English settings (Miles vs.
Kilometers). To do this, press the
/
key to show which you want, then press
Enter
.
4. Make sure the wheel size diameter is 1.83 then press
Enter
.
5. Adjust the minimum speed (if needed) to
0.5 mph/1.0 kmph
and then press
Enter
.
6. Adjust the maximum speed (if needed) to
10.0mph/16.0 kmph
and then press
Enter
.
7. Adjust the maximum elevation (if needed) to 15 and then press
Enter
.
8. Grade return
–
On (This allows the incline to return to zero when
Stop
is pressed. For sale in
Europe, EU standards require this to be off )
9. Press
Start
to begin calibration. The process is automatic; the speed will start up without
warning, so do not stand on the belt.
ADJUSTING THE SPEED SENSOR
If the calibration does not pass you may need to check the speed sensor alignment.
1. Remove the motor cover hood by loosening the 4 screws that hold it in
place (you do not need to remove them completely).
2. The speed sensor is located on the left side of the frame, right next to the
front roller pulley (the pulley will have a belt around it that also goes to the
motor). The speed sensor is small and black with a wire connected to it.
3. Make sure the sensor is as close as possible to the pulley without touching
it. You will see a magnet on the face of the pulley; make sure the sensor is
aligned with the magnet. There is a screw that holds the
sensor in place that needs to be loosened to adjust the sensor. Re-tighten
the screw when finished.
MAINTENANCE MENU
1. Press and hold the
Start, Stop
and
Enter
key at the same time, until the display shows
“Engineering mode” (it may say maintenance menu, depending on version). Press the
Enter
key.
2. You can now scroll through the menu using the
Speed
/
keys. Use the
Stop
key to return to
previous menu selection. The menu selections are:
A.
Key Test
- Will allow you to test all the keys to make sure they are functioning
B.
Display Test
- Tests all the display functions
C.
Functions
- Press Enter to access settings, use
Speed
/
keys to scroll
I.
Display Mode
- Turn off to have the console power down automatically after 30 minutes of
inactivity
II.
Pause Mode
- Turned on to allow 5 minutes of pause, turn off to have console pause in
definitely
III.
Maintenance
- Reset lube message and odometer readings
IV.
Units
- Choose from English or Metric display readings
V.
Key Tone
- Will turn on/off beeping noise that is made when keys are pressed.
D.
Securit
y - Allows you to lock the keypad so no unauthorized use of the machine is allowed. When
the child lock is enabled, the console will not allow the keypad to operate unless you press and
hold the Start and
Enter
buttons for 3 seconds to unlock the console.
E.
Exit
Summary of Contents for F60
Page 30: ...30 EXPLODED VIEW DIAGRAM ...
