Customer Service 1-888-707-1880
27
Dyaco Canada Inc. 2016
Email: customerservice@dyaco.ca
BELT/DECK
LUBRICATION
First, you want to clean between the belt and deck to remove any debris that may be trapped. Use a
clean, non-fraying rag, t-shirt, or light towel. Halfway between the end of the treadmill and motor
cover, shove the garment under the belt until you can grasp it on both sides of the belt. Drag the
garment the length of the entire belt 1-2 times. Remove the garment.
Only lubricate your treadmill with 100% silicone treadmill lubricant. Your treadmill comes with one
tube of “Lube” and extra tubes can be ordered directly from Dyaco Canada Inc. or your authorized
Sole Fitness dealer. You may also use a Lube‐n‐Walk kit that can be purchased through
bothaforementioned sellers.
Keeping the deck lubricated at the recommended intervals ensures the longest life possible for your
treadmill. If the lubricant dries out, the friction between the belt and deck rises and places undue
stress on the drive motor, drive belt and electronic motor control board, which could result in
catastrophic failure of these expensive components. Failure to lubricate the deck at regular intervals
may void the warranty.
The belt & deck come pre-lubricated. The console has a built in lubrication reminder indicator that
lights every 90 hours of use or if you notice that the deck is dry. It is recommended that you reach
between the belt and deck to verify there is lubricate procedure below even though the “Lube”
indicator isn’t Iit on the console. Otherwise, lubricate when the console’s lubrication reminder Lights
after 90 hours of use. Use the following procedure to apply the silicone Lubricant:
1. Turn the power switch off and unplug the power cord from the wall outlet.
2. Measure 18” from the edge of the motor cover; kneel down and reach under the belt
approximately 4-6” from one edge. Squirt a line of lubricant about 1/8” wide x 15” long in an
“S” pattern perpendicular to the motor cover.
3. Repeat the process on the opposite side.
4. Plug the electrical cord back into the outlet and turn the power switch on.
5. Walk on the belt at a moderate speed for five minutes to evenly distribute the silicone lube.
6. If the “Lube” message appears on the console, perform the following procedure to reset the
message:
1. To enter the Engineering Mode Menu press and hole down the
Start
,
Stop
and
Enter
keys,
then at the same time insert the
Safety key
. Keep holding the keys down until the
Message Window
displays Engineering Mode Menu. Press the
Ente
r button to access.
2. Press the
Speed
▲
button (or
Speed
▼
Button to go backwards) until “Functions”
appears; Press
Enter
.
3. Press the
Speed
▲
button UNTIL “Maintenance” message appears; press
Ente
r to reset the
Lube message.
4. Press
Stop
to exit Engineering Mode and resume use of your treadmill.
