SkyWay Series Multi-Point Operator’s Guide
15
3.
Configure the RF Base Port.
a. Go to the RF Base Port Configuration screen (1.2.3.1.1).
b. Type “.a” to add a base port configuration. You should see the following:
4.
Configure the appropriate WCOPP-AP mode.
Standby Mode (default)
a. Under WCOPP Mode field, change to Standby Mode and press Enter.
b. Type “.w” to write the record.
c. Proceed to Configuring the SkyWay Net as a Sub station or Configuring
the SkyMate Substation.
d. When finished configuring the SkyWay-Net or SkyMate Substation, go to
the WCOPP-AP Status screen (2.6.5).
e. Type “.r” to view each Sub station that is trying to associate with the Base
station.
f.
Under the Association Control field, change to Accept and press Enter.
g. Type “.w” to write the record.
h. Repeat procedure f and g for each additional Substation that you want to
accept.
Standard Mode
a. Under WCOPP Mode field, change to Standard Mode and press Enter.
b. Type “.w” to write the record.
c. Go to the WCOPP-AP Configuration screen (1.2.3.1.3).
d. Type “.a” to add a Substation configuration.
e. Under MAC Address insert the RF MAC address of the Substation.
f.
Type “.w” to write the record.
g. Repeat steps d through f for each additional Substation.
Summary of Contents for SkyMate
