1. Declaration
Note: Any changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
1
．
This device may not cause harmful interference, and
2
．
This device must accept any interference received, including interference that may
cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and radiates radio energy and, if not installed and used
in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does case harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
1
．
Reorient or relocate the receiving antenna;
2
．
Increase the separation between the equipment and receiver;
3
．
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected;
4
．
Consult the dealer or an experienced radio/TV technician for help.
The antenna(s) used for this transmitter must be installed with providing a separation
distance of at least 20cm from all persons.
2. Introduction
Contents of the CPE package:
●
CPE ×1
●
Power adapter ×1
●
Ethernet cable ×1
●
User’s manual ×1
If any of the items are missing or damaged, please contact your service provider.
The following figures (2-1 and 2-2) show the basic appearance and external functions of
the CPE. Table 2-1 describes the operating parameters.
