Solectek SkyWay-QM Quick Start Manual Download

Page: 3 / 6

SkyWay-QM: Quick Start Guide

5. Power and Grounding

•

Connect power cables
by pushing wires into
connector and using
small bladed tool to
hold open contacts.

•

Ground MUST be
used. Attach ground
lug to ground screw
and tighten with 5/16”
wrench.

6. Antenna Alignment

•

Align one antenna at a time.

•

Ensure azimuth lock bolts are tight while adjusting.

Verify power LED is lit.

Connect RSL test cable and place
voltmeter within easy viewing

Summary of Contents for SkyWay-QM

Page 1: ...upplies are optional Make sure to order them from Solectek if you do not have your own 48V power source Surge suppressors are optional and must be ordered separately V 1 1 Refer to your antenna manufacturer s installation guide to Assemble the antenna mounting kit Mount the antenna to the mast ...

Page 2: ...nting the antenna Slip fit radio over the antenna waveguide Fasten the latches at four corners 1 Install SFP modules in radio with duplex MMF or SMF fiber from the radio to the network termination equipment The cable should be looped around the inside of the enclosure to provide strain relief 2 Connect fibers at the network equipment ...

Page 3: ...ng small bladed tool to hold open contacts Ground MUST be used Attach ground lug to ground screw and tighten with 5 16 wrench 6 Antenna Alignment Align one antenna at a time Ensure azimuth lock bolts are tight while adjusting Verify power LED is lit Connect RSL test cable and place voltmeter within easy viewing ...

Page 5: ... Quick Start Guide 9 Locate Center of Main Beam 10 RSL Voltage vs dBm Chart For short links if the RSL voltage is saturated there is further adjustment capability to reduce the Tx power in the NMS user interface ...