D C D C 7 5 0 : 1 5 0 - 2 5 0 V , 1 3 . 2 V
2 0 0 V - 4 0 0 V , 1 2 V
2 0 0 - 4 0 0 V , 1 3 . 2 V
2 0 0 - 4 0 0 V , 2 4 V
Installation
9
99
9
Connections
There are
two
connections that must be made to operate your converter. Be certain that your low-
voltage input harness is connected to your 12V system. Make the 2-pin Anderson SB-50
low voltage
output system connection to your low-voltage input harness
, as shown in
photos one and two.
Low Voltage Output: Anderson Connector
Photo One
Photo Two
To bring
high voltage input
power to your unit you must connect the three-pin, two-wire high-
voltage input Deutsch connector to your
high-voltage output harness
, as shown in photos three and
four.
Photo Three
Photo Four
High-Voltage Input: Deutsch Connector
Operation of your converter begins as soon as the unit is connected to a power source.
If your unit is not operating after having been linked to a power source,
carefully
check for possible
loose connections. If you are still experiencing difficulties in getting your unit to begin operation, call
the Solectria Customer Service Department at the number provided in your warranty.
Reminder
Always use connector
grease for all Anderson
SB-50.
