Installation and Operation Manual (Rev B)
31
4. If the network is not working on the Ethernet protocol level, such as if the twisted pair
Ethernet cable is not plugged in, the following will be displayed:
Manually Configuring Network Settings
To manually configure network settings:
1. Select
Config
from the
Main Menu
then press
ENTER
.
2. Select
LAN
from the
Config
Menu
then press
ENTER
.
3. Select the
DHCP
function then press
ENTER
to edit the setting.
4. Press the
DOWN
button to turn
DHCP Mode
Off
then press
ENTER
to save this setting.
The
DHCP Mode
setting will now show
OFF
.
5. Press the
DOWN
button to access the
Static IP
setting.
6. Press
ENTER
to modify the
Static IP
value.
7. Specify each of the four octet values (0-255), one at a time. Press the
UP
button to
increment the octet. Press the
DOWN
button to decrement the octet. Press the
ENTER
button to accept the octet. Press the
ESCAPE
button to cancel entry at any point. When
the fourth octet is entered the entry will be saved.
