Installation and Operation Manual (Rev B)
32
8. Press the
DOWN
button to access the
Gateway
setting.
Change in the same manner that the
Static IP
was modified.
9. Press the
DOWN
button to access the Netmask setting.
Change in the same manner that the
Static IP
was modified.
Automatically Configuring Network Settings
When shipped from the factory, the SolrenView gateway uses DHCP to configure the TCP/IP
settings. If the gateway has been changed to use static IP address the following instructions will
explain how to turn on DHCP.
To configure the SolrenView gateway to use DHCP:
1. Select
Config
from the
Main Menu
and press
ENTER
.
2. Select
LAN
from the
Config
Menu
and press
ENTER
.
3. Select the
DHCP
function and press
ENTER
to edit this setting.
4. Press the
DOWN
button to turn
DHCP Mode
On
and press
ENTER
to save this setting.
The
DHCP Mode
setting will now show
ON
.
Setting Fallback IP Address
When the SolrenView gateway is set to use DHCP, but is unable to acquire an IP address lease, it
will “fallback” to using a specified IP address after a few seconds.
To specify a fallback IP
1. Select
Config
on the
Main Menu
and press
ENTER
.
2.
Select
LAN
from the
Config Menu
and press
ENTER.
3. Confirm that the
DHCP Mode
setting shows
ON
.
The Fallback IP is only available when DHCP is turned on.
4.
Press the
Down
button to show the Fallback IP setting.
5. To change the Fallback IP, press the
ENTER
button.
6. Specify each of the four octet values (0-255), one at a time. Press the
UP
button to increment
the octet. Press the
DOWN
button to decrement the octet. Press the
ENTER
button to accept
