5
OPERATING INSTRUCTIONS
1) When first operating the dehumidifier, run it in Continuous mode for 24 hours.
2)
Power On and Off
- Press the
POWER
button once to manually turn the unit on. Press the
POWER
button once more to turn the unit off.
3)
Humidity Selection
- Press the
“
+
”
or
“
-
”
buttons to choose the desired relative humidity in the room.
Each press of the button will change the desired room humidity by 5%. The room humidity is selectable
from 35%-80% or continuous. The unit will cycle on and off to maintain the humidity level chosen on the
digital display. If you want the dehumidifier to operate continuously regardless of the room humidity, press
the (
+
)
or (
-
) buttons until you see “
80
” or “
CO
” on the digital display. This will enable
continuous op-
eration
and the “
Continue
” indicator will light up on the control panel.
4)
Fan Speed Control
- Press the
FAN SPEED
Button to cycle through the different fan speeds:
High,
Medium, and low
. The fan speed can be visually distinguished by the fan speed indicators on the control
panel.
5)
Timer
- To program the unit to automatically turn off, press the
TIMER
button when the unit is on. You
can select either 2 or 4 hours with the Timer. Once the desired time (2 or 4 hours) is over, the unit will
automatically shut down.
6)
Bucket Full
- When the water bucket is full of water, the unit will automatically shut off and the
Bucket
Full Indicator
will light up. The dehumidifier will not function until the water bucket is emptied and
placed back inside the unit. The bucket should be cleaned every few weeks to prevent the growth of mold,
mildew and bacteria. Use a mild detergent to clean the bucket. Once clean, completely dry the bucket and
place it back inside the dehumidifier.
7)
Replace Filter
- When the filter needs to be replaced, the filter indicator will
light up. Remove the filter and clean with warm, soapy water. Dry thoroughly be-
fore replacing the filter. Once the filter is completely dry, place the filter back in
the unit and press the
FILTER
button to reset the filter indicator.
OPERATING INSTRUCTIONS
NOTE: Support bucket with
both hands when emptying
