9)
Bucket Full
-
When the water bucket is full of water, the unit will automatically shut off , make a beeping
noise, and the Bucket Full Indicator will light up. The dehumidifier will not function until the water bucket
is emptied and placed back inside the unit. The bucket should be cleaned every few weeks to prevent the
growth of mold, mildew and bacteria. Use a mild detergent to clean the bucket. Once clean, completely dry
the bucket and place it back inside the dehumidifier.
NOTES:
When the bucket is full or removed from the machine, the compressor will turn off, but the fan will
continue to run for a few minutes. This is completely normal. The dehumidifier will not be removing moisture
from the air at this time.
When removing moisture from the air, the dehumidifier will exhaust warm air from
the side exhaust vent. Do not place a full bucket on the floor, because the bottom is uneven.
10)
Clean Filter
-
When the filter needs to be cleaned, the filter indicator will light up (after 250 hours of use).
Remove the filter from the back of the unit by using your thumbs to press down on the filter tabs directly
above the filter. Clean the filter with warm, soapy water. Dry thoroughly before replacing the filter. Once the
filter is completely dry, place the filter back in the unit and press the FILTER button to reset the filter indica-
tor.
CAUTION: DO NOT OPERATE THE DEHUMIDIFIER WITHOUT THE INCLUDED FILTER
OPERATING INSTRUCTIONS
NOTE: Do not clean filter in dishwasher
