6
BASIC ASSEMBLY
To properly assemble this heater you need the supplied assembly wrench and Allen wrench (or one of your
own). Refer to the parts diagram on page 5 while assembling the heater.
1) First, attach the base pole (F) to the weighted base (B) using the 3 base bolts (I) and 3 nuts (J). Once you
secure the base pole to the weighted base (B), place the decorative cone (C) over the base pole (F) to
cover the bolts on the base.
2) Next, place the power cord attached to the heater head (A) through the middle of the top pole (E). The top
pole (E) will have two smaller screw holes located at the top and larger screw holes at the bottom. Align
the small screw holes with the holes on the bottom of the heater head. Use the small heater head connector
screws (H) to secure the heater head (A) to the top pole (E).
3) After securing the heater head and top pole, place the cord through the pole connector (D) and connect it
to the bottom of the top pole (E). Align the screw holes on the pole connector (D) with the screw holes on
the bottom of the top pole (E) and secure using 3 of the supplied pole connector screws (G).
