7
4) Now, place the power cord through the base pole (F) and base (B) you assembled earlier. Make sure the
cord is pulled all the way through the base to provide optimal length. Once the cord is placed through the
base, connect the base pole (F) to the pole connector (D) on the bottom of the top pole (E). Align the
screw holes on the pole connector with the screw holes on the top of the base pole and secure using 3 of
the supplied pole connector screws (G).
5) Before using the heater, align the power cord with the cutout on the weighted base and secure using the
attached fasteners on the bottom of the weighted base. There is one fastener located near the middle of the
weighted base, and another fastener located near the cutout at the end of the base. Place the cord through
each fastener and tighten to secure the cord to the base. After securing the power cord to the fasteners,
place the rubber ring located around the power cord in the cutout on the weighted base. Properly attaching
the power cord to the weighted bases will allow the heater to be moved easily and prevent damage to the
power cord.
