NOTE: If there is not a secure connection between the hose cap and the connector on the water cooler,
the water pump will operate but the water cooler will not dispense water. Make sure the hose is con-
nected to the water cooler correctly.
NOTE:
Please wait until the water pump stops running before using the unit. If the water tank is not full, no
water will dispense from the cold water faucet and the hot water faucet.
7
1. Make sure the water dispenser is not plugged into an electrical out-
let.
2. Open the door of the lower cabinet.
3. Place a full water bottle in the center of the cabinet. Remove the
plastic cover over the mouth of the water bottle.
4. Put the hose inside the water bottle and place the water bottle cap
firmly over the mouth of the water bottle.
(
Figure 1
）
5. Attach the hose to the water cooler by pressing in on the knob of the
hose cap and sliding over the connector at the top of the cabinet.
（
Figure 2
）
6. Center the water bottle and close the lower cabinet door.
7. Plug the water cooler into a grounded power outlet and turn on the
power switch located on the back.
8. The unit will start to operate, but you should wait at least half an
hour before using the water cooler.
