12’ Garden Master, Page 27
15.
Door lock
- The center cross bar of the door will set the height of your door
lock/handle. From the outside of the greenhouse, look through the door panel
at the holes in the predrilled snap-T, this would the height of the outside door
handle. To adjust to your prefered handle height, slide the cross bar up or
down using a rubber mallet. Make sure to level.
From the outside of the greenhouse, use a sharp thin bladed knife and push
the blade of the knife through the panel and into the large predrilled hole. Do
this twice so that you are cutting an “X” in the panel right where the predrilled
hole is at and then twist the knife when it is in the hole, do the same thing for
the smaller predrilled hole. See picture “A” to the right.
Now you will install the outer door handle. This handle has a thin nut included
in the bag, remove that nut and keep it close by.
Insert the shaft of the door lock handle through the door panel and into the
large hole of the door cross bar. You may need to twist or screw this into the
hole. The handle should be flush with the door panel. Next, twist the door han-
dle so that it is perpendicular to the metal plate that is just behind that handle
(that plate is a part of the lock, there are two holes in that plate, you cannot
see them unless you twist the handle on the outside door handle). See picture
“B” to the right.
Insert the 32 x 1¾” flat head screw (the long one in the lock kit) through the
hole that is closest to the middle of the door, the tube is predrilled behind this
hole. Attach the 1” Metal Screw into the other hole (this hole is not pre-drilled)
- this will lock cross bar in place - so make sure the bar is level.
A
B
32 x 1-3/4” Screw
1” Metal Screw
