PRODUCT MANUAL
8-Zone RGB Remote Control
8-Z
one R
GB R
emot
e C
on
tr
ol
™
Toll Free: 866.592.3873
Email: sales@solidapollo.com
www.SolidApollo.com
This section will show you how to pair your new 8 Zone Controller with the receiver for one zone.
Pairing the 8 Zone Controller with receiver
HOW TO PAIR SEVERAL RECEIVERS TO THE REMOTE CONTROL:
The LED Wizard remote control has 8 zone control buttons. Each zone button can
control 1 or more receivers.
Let’s make a configuration example:
You have 5 different zones to control in your in
-
stallation. Therefore you will have 1 remote control and 5 receivers for each zone. You will
need to program each receiver to what number zone they belong. Once the receivers have
been correctly wired and powered we will start to define and pair each receiver with its
own zone.
Step 1:
A.
Press the red power button in the remote control
B.
Now press any button from 1 to 8 depending in which zone you want to assign to the
receiver, in this case we will press button “1” on the remote
C.
Quickly Tap the learning button on the white receiver
D.
Immediately start sliding your finger in the rainbow circle of the remote control, if cor
-
rectly done, you will see the red LED light blink on the
receivers. It will blink for about 3
seconds. Once it stops blinking the receiver has been correctly paired.
E.
Repeat this with other receivers. You can pair all receivers to the same channel, in this
case 1, or have them in different channels 1-8
If by any circumstance you wish to reprogram any of the receivers, you will
need to “reset” the receiver. To do this, simply press the learning button for 5 seconds until
the red LED lights shuts off, and re-do steps A-E above.
A.
B.
C.
D.
On Receiver
Page 5
...continued on next page
C.
Learning Key Button Location
