GARDEN SHED
– MODERNA2 13 x 10 (1 1/8’’)
12
ASSEMBLING ROOF BEAMS
Fixing of protective wind studs
Pic. 1
Fix the protective wind
studs to the gable with
0.23x2.3 inch screw in
the middle of groove
Pic. 2
Fix the protective wind
studs to the lower wall-
board with a 0.15x1.5 inch
screw.
POSITION
DESIGNATION
DIMENSION
(inch)
QUANTITY
23
Beams
168.90 x 5.51 x 1.73
3
24
Front protective wind studs
82.67 x 1.57 x 0.62
2
25
Back protective wind studs
80.70 x 1.57 x 0.62
2
When the gable is well positioned, the
beams
(part no. 23) can be installed. Fix them to
the gable with 0.19x2.75 inch screws.
Strengthen the construction with
protective wind studs
(part no. 24 and 25) as shown
in figure 1 and 2 by drilling through the wall at the top. Finger tighten only so the washer
can spin easily to allow the wood to retract and expand.
Make sure the top of the wind
stud is at least 1” below the roofline.
NOTE. The protective wind studs can also be installed from the outside of a shed
or skipped if you live in a low wind area.
Check if the
door closes properly
. At this time, you can still shift the whole structure
by pushing to the sides as needed to square the door frame. The structure will lock once
you install the roof boards. If the door still "sticks" at the top or bottom, adjust the hinges
using an Allen wrench. You can shift the angle and height of the door by adjusting the
hinges on the door panels.
