Reproduction is permitted provided copyright information is intact.
The main antenna
is almost completely
assembled when you get
it. All you need to do is
separate the antennas
(the x-shaped part) from
the reflector (the bars
with the plastic.)
Find the wingnuts
roughly halfway between
the outer edge of the main
antenna and the center
and loosen them slightly.
Pull the antenna away
from the reflector until it
cannot go any further.
Tighten the wingnuts
to keep the antenna
separated from the
reflector.
You will need to do this
with both assemblies.
There are two wingnuts
on each assembly.
PUTTING TOGETHER THE MAIN ANTENNA ASSEMBLY
