Reproduction is permitted provided copyright information is intact.
ATTACHING THE ARMS TO THE ANTENNA ASSEMBLIES
Start by laying out the antenna
assemblies and the arms. Lay the
antenna assemblies upside down, so the
black plastic boxes in the center of each
assembly are facing down. Lay out each
assembly so that the cables are toward
the bottom.
Then lay out each arm. One arm has a
combiner as shown at left.
The arm with the combiner goes at the
bottom of the antenna, and the combiner
goes on the underside (so that when
everything is assembled, it will be at the
front.) Also, the wingnuts at the edges
should point toward the bottom.
Take some time to make sure that
everything is facing the same way, This
will save you a lot of time later.
