T
HERMO
C
UBE
PAO
C
HILLER
P
ART
#
52-400-2G-1-PAO
S
OLID
S
TATE
C
OOLING
S
YSTEMS
,
167
M
YERS
C
ORNERS
R
OAD
,
W
APPINGERS
F
ALLS
,
NY
12590
12
T
ELEPHONE
:
(845)
296-1300
F
AX
:
(845)
296-1303
WEB
V
ERSION
M9
Status Menu:
The status menu displays the chiller operating status and
coolant temperature. The chiller operating mode is shown in the
display’s first character: (See Figure 5)
Figure 5: Operating Display
* = Standby mode, chiller is not controlling temperature
‒ = Cooling mode, chiller is controlling temperature and process
fluid temperature is above the set point
+ = Heating mode, chiller is controlling temperature and process
fluid temperature is below the set point
The process fluid (coolant) outlet temperature is shown after TEMP in
°C or °F.
Pressing the UP or DOWN keys with the # of cycles set to zero
(default) will change the set point temperature upon pressing the
ENTER, then the START/STOP key.
Temperature Input Menu:
The temperature input menu allows input of
operating temperatures, soak times, number of cycles desired, and an
optional alarm temperature. Note: If # of cycles is set to zero, only
TEMP 1 and ALARM TEMP will be used.
SETTEMP1 = Set-point of first control temperature.
If # OF CYCLES is set to zero, this is the control temperature.
SETTIME1 = Soak time at temperature 1.
Not used if # OF CYCLES is set to zero.
SETTEMP2= Set-point of second control temperature.
Not used if # OF CYCLES is set to zero.
SETTIME2 = Soak time at temperature 2.
Not used if # OF CYCLES is set to zero.
# OF CYCLES = Number of cycles between temperature 1 and
temperature 2, 0-999 cycles. If set to zero, then the ThermoCube
will continuously control at temperature 1.
ALARMTEMP = Alarm temperature range +/- set-point. The unit will
output an alarm dry contact or TTL signals, but not RS-232.
‒ TEMP 20.0 °C
Temperature Units
Process Fluid Temperature
Operating Mode
