T
HERMO
R
ACK
800
T
HERMOELECTRIC
C
HILLER
52-13007-1
S
OLID
S
TATE
C
OOLING
S
YSTEMS
,
167
M
YERS
C
ORNERS
R
OAD
,
W
APPINGERS
F
ALLS
,
NY
12590
9
T
ELEPHONE
:
(845)
296-1300
F
AX
:
(845)
296-1303
WEB
:
WWW
.
SSCOOLING
.
COM
V
ERSION
M8
3.1
M
ECHANICAL
I
NSTALLATION
The ThermoRack 800 is designed for installation into EIA-310-C
standard 19 inch electronics rack. The chiller must rest on two rails, at
least 16 inches in length, installed into the electronics rack. Rails may
be purchased from SSCS, PN 30-22737-1, or from Allied Electronics
PN 806-6880. Place the chiller on top of these rails and slide into
place. Once in place, use four #10 mounting screws to fasten the chiller
to the electronics rack. Easy access must be given to the power inlet
(located above the plumbing connections on the back panel of the unit)
to allow for service.
Air Considerations:
The air inlet and outlet are located on the front and back sides
respectively. Restricting airflow into or out of the unit will impair
performance. At least 6 inches of clearance is required in front and in
back to ensure adequate airflow.
3.2
E
LECTRICAL
C
ONNECTIONS (
SEE FIGURES
3A
AND
3B)
Power: The ThermoRack 800 AC power inlet is an IEC320-C20 socket.
Plug the line cord provided into this socket and then into the
appropriate power source. The standard line cord provided has an L6-
15P plug for a 208/240 VAC 15 Amp 60 Hz outlet. To ensure safe
operation of the unit, it is important to ensure that the AC power cord is
properly grounded.
Various regional power cords are available to support universal power
operation:
Country / Region
Part Number
US NEMA 6-15 208 Straight 250V
22-26098-9
US NEMA L6-15 208 Twist 250V
22-26098-10
Europe 250V
22-25201-1
UK 250V
22-26098-4
Israel 250V
22-26098-5
Australia 250V
22-26098-6
Korea 250V
22-25201-1
China (3 prong) 250V
22-26098-8
US/Canada 125V (TR7 Only)
22-25200-1
Japan 125V (TR7 Only)
22-26084-1
Fuse: 10 amp (5mm x 20mm F10A 250V) for 200-240 VAC
15 amp (5mm x 20mm F15A 250V) for 115-125 VAC
Remote Communication: Remote control of the unit may be achieved
by connecting to the USB type B port on the rear panel. For more
information, refer to section 7.2.
WARNING
Electrical Shock
Hazard: Never Plug
in a Line Cord with
Wet Hands