Appendices
38
THE BUS+ User Guide
Safety Notices
General Safety
• Please read and keep this document.
• Adhere to all warnings and follow instructions.
• This electrical equipment should not be used near water, rain or moisture.
• Clean only with dry cloth or products compatible with electrical devices and never when the unit is powered.
• Keep the unit free of dust and use in a clean environment.
• Do not use near any heat source, indirect sunlight or naked flames.
• Do not place heavy objects on the unit.
• Only use attachments/accessories recommended by the manufacturer.
• Unplug the device during lightning storms or long periods of non-use.
• The unit can only be serviced by qualified personnel – seek immediate service if:
- The unit has been exposed to moisture
- The unit has been dropped
- The unit does not operate normally
• Do NOT modify this unit, alterations may affect performance, safety and/or international compliance standards.
• SSL does not accept liability for damage caused by maintenance, repair or modification by unauthorised personnel.
Installation Notes
• When installing this apparatus either fix it into a standard 19” rack or place it on a secure level surface.
• If the unit is rack mounted, fit all rack screws. Rack shelves are recommended.
• When rack mounting, allow a 1U gap above and below the unit for cooling.
• Ensure that no strain is placed on any cables connected to this apparatus. Ensure that all such cables are not placed where
they can be stepped on, pulled or tripped over.
Power Safety
• Bus+ is supplied with a mains lead however if you wish to use a mains cables of your choice it must comply with the following
standards:
-
Refer to the rating label on rear of the unit and always use a suitable mains cord.
-
The unit should ALWAYS be earthed.
-
Please use-compliant 60320 C13 TYPE SOCKET. When connecting to supply outlets ensure that appropriate sized
conductors and plugs are used to suit local electrical requirements.
-
Maximum cord length should be 4.5m(15’).
-
The cord should bear the approval mark of the country in which it is to be used.
• The appliance coupler is used as the disconnect device, ensure that it is connected to an unobstructed wall outlet.
• Connect only to an AC power source that contains a protective earthing (PE) conductor.
• Only connect units to single phase supplies with the neutral conductor at earth potential.
DEN
Apparatets stikprop skal tilsluttes en stikkontakt med jord, som giver forbindelse til stikproppens jord.
FIN
Laite on liitettävä suojamaadoituskoskettimilla varustettuun pistorasiaan.
NOR
Apparatet må tilkoples jordet stikkontakt.
SWE
Apparaten skall anslutas till jordat uttag.
