GENESIS
TM
DAS Operation Manual - Version 0.0 – Jan. 2019
©2019 SOLiD, Inc. All Rights Reserved. Confidential & Proprietary.
Page 26
Do not stretch the fiber.
Make sure the bend radius of the fiber is not less than 2inches(5.08cm)
User can add or remove SFP modules in LRN without powering off the system. To insert an SFP module:
Holding the SFP module by its sides, insert the SFP module into the port on the LRN
Slide the SFP module into the port until you hear it click. If the SFP module has a handle, push
up on the handle to secure the SFP module.
To remove an SFP Module:
Disconnect the optical cable from the SFP module.
Unlatch the SFP module
Pull the SFP module out of the port on the LRN
WARNING!
Optical SFPs contain Class 1 lasers. Invisible laser radiation can occur when laser connections are unplugged. Do
not stare into the beam. This device is compliant with FCC 21 CFR 1040.10 and EN60825-1 :2007.
Use of unauthorized antennas, cables, and/or coupling devices not conforming with ERP/EIRP and/or indoor
‐
only
restrictions is prohibited.
LRN’s SFP cage direction is horizontal type. So user install SFP module horizontally to optical port like
below.
User should use optical fiber cable based on SFP type (only duplexer).
1. SFP optical port
2. SFP transceiver
3. Fiber optic cable
4. SFP handle