Manual - BlueGEN BG-15 Generic Installation Manual - Europe
© SOLIDpower GmbH 2019
10
If installing a domestic hot water tank adjacent to the service connection side of the BlueGEN appliance, a
minimum clearance of 500mm is required between the BlueGEN and the tank. This clearance will provide
sufficient room for all ancillary equipment.
1.
Wall
2.
500mm clearance (minimum)
3.
Domestic hot water tank
Figure 4: Clearance between BlueGEN and tank
As shown in Figure 5, a minimum clearance of 500 mm is required above the cabinet to any permanent
structure to allow access to the BlueGEN appliance. If BlueGEN will be installed on a plattform the height
should not exceed 150 mm for maintenance reasons.
Figure 5: Permanent structure