U
SER
M
ANUAL
M
ARCH
2017
SolidRun Ltd
www.solid-run.com
Page 10 of 22
7 HaMada Street, Yokne’am Illit, Israel
Switch 1
Switch 2
Switch 3
Switch 4
Switch 5
SPI
Off
Off
Off
On
Off
SD/eMMC
Off
Off
On
On
On
M.2 SSD
On
On
On
Off
Off
UART
Off
On
Off
Off
On
Table 1 Boot Selection Table
For additional insights on operating system, please visit the
Downloads
section of our
home page
.
Additional extensive resources are available in the
Support
section of our Wiki.
4.4
M
ICRO
USB
CONNECTIVITY
(UART
TO MICRO
USB)
The ClearFog Base Single Board Computer has an FTDI 230x UART to USB bridge allowing convenient
connection to the device console. This configuration is typically used by developers for debugging
purposes (e.g. kernel or drivers). Such serial console connection is of USB-to-UART type. The
connection speed should be set to 115200 bps. Further information is displayed on our wiki page with
tags #
UART
& #
serial
& #
console
.
4.5
LED
S
There are multiple LEDs on the ClearFog Base Single Board Computer. These are indicating for
example power on, connection and port activity. Ethernet port related LEDs are embedded in the
RJ45 connectors, while the power indicator LED is located on the ClearFog Base Board. For further
details, please refer to our
wiki.solid-run.com
pages.
Figure 5 Location of LEDS on the ClearFog Base
4.6
SIM
CARD SLOT
/
S
It is possible to utilize a Cellular connection by inserting a SIM card into the SIM card slot. Please note
that a GSM Cellular modem needs to be installed utilizing the M.2 2242 slot in order to exploit the
cellular connection.
Summary of Contents for ClearFog
Page 1: ...ClearFog Base User Manual...
