Page 4
broadcast digital processor -
SOLIDYNE 462
dsp
About this manual
User’s manual
July 18, 2007
462dsp/AM firmware
2.1
All rights reserved.
No part of this manual can be
reproduced, be copied or be transmitted in any
form or by no electronic or mechanical procedure:
or in its totality or partly.
What s in the box?
You must find the following components into the
box.
ü
1 Solidyne 462dsp/AM processor
ü
1 user’s manual
ü
1 AC Interlock
ü
1 CD-ROM with VirtualRack 5 software.
ü
1 Guaranty certificate
ü
4 self-adhesive rubbers tops
Please check when receive to verify that all
components are okay.
About the montage
462dsp/AM processors are designed for rack
montage in standard racks of 19”, requiring 2 rack
height units. If you prefers, the processor can be
placed on a table. Four self-adhesive rubber tops
are given for this purpose.
When mounting, start fitting the bottom screws,
and soon the superior ones. Use flat screws with
flexible o-rings (rubber, PVC, etc.). The frontal
panel is made of aluminum, so you must take
special care of don’t to apply excessive force on
the screws since it can cause deformation or even
break the angles of the panel.
ADVICES
AC
Voltage
The unit cans wok with
110 or 220 VAC.
A voltage switch on the rear panel selects
the correspondent voltage.
ALWAYS CHECK THIS SELECTOR
BEFORE PLUG IN.
In order to reduce the risk of electrical shock, do not retire the
covers of the cabinet. The internal pieces do not require
maintenance of the user. Refer the technical maintenance to
qualified personnel.
The power cord provided with the unit gives
Earth return to the processor. Do not replace it
nor uses adapters.
MAKE SURE THAT HAVE WITH A GOOD
GROUND TAKING.
The exclamation icon within a triangle that
appears in this manual is for alerting to the user
about the presence of important instructions on
the operation and maintenance of the
equipment.
Letter “i” within a circle that appears in this
manual is for alerting to the user about the
information; advices and tips of extreme
importance.
