EN
Wireless Doorbell User Manual for Solight 1L67,1L67B,1L67DT,1L67DZ series
Dear Valued Customer, allow us to thank you for purchasing our product. Please read the following
instructions carefully and follow them to ensure that your product serves you safely and to your full satisfaction. Avoid an
incompetent manipulation with the device and always follow general principles of using electric appliances. Make sure to retain the
present operating manual. Intended for household or indoor use. The product should only be used by adult persons. Never expose
the receiver to environments with high humidity (such as bathroom), avoid contact with fluids.
Description
The doorbell operating frequency is 433 - 433.92MHz. The max. operating range is 200m in open area.
Inserting the battery into the transmitter
Transmitter transmitter location
Before mounting the transmitter, make sure that the doorbell works properly by plugging the receiver into the socket (AC 230V)
where you want to use it and then pressing the button on the transmitter where you want to mount it. The transmitter is waterproof,
it can be placed outdoors if necessary. However, prefer a place to protect the transmitter from water and excessive heat. The
transmitter can be mounted on a base using a double-sided self-adhesive pad or screws with dowels, without or with a protective
canopy:
Doorbell control
Select the melody
using the button as shown above. Press the button to play and change individual melodies. The selection is saved
automatically.
Change volume
with the volume change button as shown above. The volume level changes from the lowest to the highest and back
again, there is always one beep.
The Pairing
(The "Learning code") function allows you to pair several bells or buttons into one group, or to re-establish the connection
between them. It is possible to ring one bell with several buttons or to ring several bells with one button. A maximum of 15 buttons
can be paired with one bell. One button can be paired with up to 8 bells.
Assigning a new transmitter to a receiver:
1. Plug the receiver into the power socket. Press and hold the melody button for 3-4 seconds. The LED starts flashing quickly. Release
the volume button and let the LED flash.
2. Move the transmitter closer to the receiver and press once. The selected melody is played.
This assigns the transmitter to the receiver. The original transmitter is also assigned. Shown in Fig. 1 below. You proceed in a similar
way when assigning a new receiver to one transmitter. All previously paired receivers are also assigned to the transmitter. Shown in
Fig. 2 below.
Unpairing the buttons from the receiver, a reset of the connection
:
If you have more than one transmitter paired to the receiver, you may need to unpair one of the transmitters. It may also be that the
wireless connection has stopped working.
Perform the following steps:
1. Unplug the receiver. Press and hold the melody button while plugging the receiver into the power socket. Keep the button pressed
until the LED starts flashing quickly. Then release the button. The connection memory is cleared. The transmitters do not ring.
2. Follow the previous paragraph - Assigning a new transmitter to a receiver. You are reconnected.
Use a flat-blade screwdriver to push in on the latch and open the cover.
Insert a 3V CR2032 battery, observing the marked polarities. Then close
the cover.
