Getting Started
1. Download the software from: www.solinst.com/downloads
and install Levelogger Software on your PC.
2. Install the Wellhead batteries. The Wellhead uses 4 user-
replaceable 1.5V AA lithium batteries.
3. Connect the Wellhead and logger to the Vented Cable:
Support
Hanger
Bracket
- 2 -
Note:
See page 6 for instructions to install the Support Hanger
Bracket, as shown at right.
Note:
For information on using your AquaVent logger with
MODBUS or SDI-12 protocols, see separate User Guides.
Battery
Compartment
SP
Wellhead
Vented
Cable
AquaVent
Logger
10-Pin (SP)
Connection
Alignment socket in the
Vented Cable connectors
Alignment pin in the Wellhead
and logger connectors
Coupling
Connector
Body
Line up the alignment socket in the Vented Cable connector with the
alignment pin in the Wellhead connector.
Carefully
push the connectors together. Twist the cable connector
slightly
until you will feel a
small click
when the properly aligned
connection is made.
Tighten the stainless steel coupling while holding the stainless steel cable
connector body still. Tighten the coupling until it seats.
Do not twist the
Vented Cable or Wellhead.
Follow the same procedure when connecting the logger to the Vented
Cable.
Well Cap
Base
