Remote Radio Link User Guide
Page 16
Step 5: Configuring Attached Dataloggers
In this step you will select the number and types of dataloggers connected to the RRL Station.
The connectors for dataloggers on the RRL Stations are identified as Right and Left. This assumes the RRL
Station is facing with the black label towards you. If using a Splitter, the number 1 or 2 will identify the
dataloggers. The numbers 1 and 2 are labeled directly on the connections of each Splitter.
For each connection you will select the type of datalogger attached. Select ‘NONE’ for connectors with no
datalogger attached. After selecting the datalogger type from the drop down menu, an image of the selected
datalogger will be displayed.
Note:
The firmware versions shown in red for each datalogger, are the firmware versions that will work with the
current Solinst Telemetry Software version.
To optionally set each datalogger to record in their internal memory
, select
Edit
to begin entering data
collection information.
Note:
Dataloggers programmed to record and store readings in their internal, non-volatile memory, provide reliable
back-up data. This will, however, cause their internal battery to be used up more quickly.
You
must
program a Rainlogger in order to enter a Rainfall Calibration Constant (the amount of rainfall per
tip of the connected rain gauge), but you do not have to set it to record independently.
Select Next, without editing any datalogger settings, if you do not want to set your dataloggers to record
independently.
Figure 4-8 Adding Dataloggers
Summary of Contents for Remote Radio Link
Page 1: ...Solinst Remote Radio Link RRL User Guide November 6 2018...
Page 51: ......
