75
74
B. MOUNTING THE SAFETY GRIDS AND THE ROTOR BLADE
ON THE MOTOR CASING
•
Unpacking the safety grids
1.
Open the transparent fastener clip on the front safety grid by folding it out. The
clip stands at a 90° angle to the safety grid. Make sure not to push the clip to
far out and breaking it off.
2.
Take the front safety grid off of the rear safety grid.
3.
Discard the packaging materials and take the rotor blade out of the plastic fi lm.
•
Mounting the safety grids and the rotor blade
4.
Unscrew the rotor blade nut (
2
) from the motor shaft (
6
). Then, unscrew the
rear nut (
4
) from the motor casing. Unscrew the rotor blade nut by turning it in
a clockwise direction (towards “Loosen”). Unscrew the rear nut by turning it in
a counter-clockwise direction.
5.
Push the rear safety grid onto the motor casing and over the threads. Rotate it
so that the 3 positioning pins on the motor casing keep the rear safety grid in
position (the two small holes are on top). (Fig. 1 and 2)
6.
Use the rear nut to fasten the rear safety grid (
4
). To do that, turn the rear nut
in a clockwise direction towards “Tighten”. (Fig. 3)
7.
Now, push the rotor blade onto the motor shaft, the 2 pins on the motor shaft
have to slide into the two grooves in the rotor blade base. (Fig. 4)
8.
Fasten the rotor blade with the rotor blade nut (
2
) by turning it in a coun-
ter-clockwise direction towards “Tighten”. The rotor blade should be able to
spin freely. (Fig. 5)
9.
To fasten the front safety grid to the rear safety grid, align the little clip on the
frame of the front safety grid with the two little notches on the top of the frame
of the rear safety grid. Link the two parts together. (Fig. 6 and 7)
10.
Then, carefully push the frame of the front safety grid against the rear frame so
that the fastener clip on the bottom of the front frame can be closed and locks
into place. (Fig. 8 and 9)
11.
When the fan is correctly assembled you can start using the appliance. (Fig. 10)
Fig. 3
Fig. 1
Fig. 2
Fig. 4
Fig. 6
Fig.5
Fig.10
Fig. 7
Fig. 8
Fig. 9
notches
clip
GB
GB
