GB
GB
87
86
●
NOTE:
Humidification will be even more effective if the filled water is not very
cold. However, the water temperature should not exceed 30°C, otherwise the
humidification disks and other appliance parts might be damaged. To prevent
fast calcification, you can use filtered water if the water is very calciferous.
However, slight limescale on the humidification disks improve the humidification
power, as the microstructure of the limescale causes even more water to stick
to the disks.
●
Make sure that the shaft with the humidification disks is correctly placed in the
receptacle in the water tub. The cogwheel of the humidification disks should be
positioned in the rear end of the tub.
NOTE:
The humidification will only fit the
receptacle if the cogwheel is positioned in the rear end of the tub.
●
Cogwheel
Shaft
Screw the lid back onto the water tank and turn the tank upside down.
●
Lock the appliance backside with the water tank back into the appliance.
●
You should be able to hear the burbling water flow from the tank into the water
tub with the humidification disks.
●
Plug the power plug into the power outlet. The LED lights up in red and a signal
sounds, the appliance is in standby mode. In standby mode, only the
;
button
can be used to activate the appliance.
●
NOTE:
If you have filled the water tank for the first time, the water might smell
or change in colour. This is normal and has no negative effect on the function-
ality of the appliance or your health.
s
THE FUNCTION BUTTONS
●
The function buttons are touch sensitive sensor buttons. Briefly touching the
function buttons will switch on the corresponding functions and illuminate the
respective function displays. Every touch is accompanied by a signal sound.
●
NOTE FOR DISPLAY BRIGHTNESS:
After switching the appliance on or after using a button, the display lights up
brightly. After a while, it dims down automatically.
ON / OFF BUTTON
●
As soon as the power plug is connected to the power outlet, you can activate
the Airwasher with the
;
button. A signal sounds, the display states
Hi!
for
2 seconds, then it starts alternating between showing the current settings and
data:
– ventilation power
– humidification power
– current room humidity
– timer setting (if activated)
●
When using the appliance for the first time and when plugging in the power
plug after having it disconnected, the following default settings are set: slow
ventilation (
SL
) and continuous humidification (
CO
).
●
Touching the
;
button again switches the appliance off. A signal sounds, the
display briefly states
OFF
, then the display goes dark and the appliance switches
off within 2 seconds.
VENTILATION SPEED BUTTON
●
You can use this button to choose from four ventilation speeds:
–
SL
for slow ventilation speed
–
LO
for low ventilation speed
–
MI
for medium ventilation speed
–
HI
for high ventilation speed
●
Touching the button again after the HI setting will set the ventilation speed back
to the SL setting (slow).
