GB
GB
89
88
HUMIDIFICATION POWER BUTTON
●
You can use this button to set the desired room humidity. The following settings
are possible:
40 %
50 %
60 %
70 %
CO
for continuous humidification
●
Each touch of the button increases the value by 10 %. Above 70 %, the conti-
nuous humidification (
CO
) is activated. If the set value (between 40 % and 70 %)
exceeds the current room humidity, the appliance works in the set ventilation
speed to achieve the set value. Once the set value has been reached, the appli-
ance stops. It reactivates if the room humidity drops below the set value.
●
In the
CO
function, the room air is humidified continuously without a concrete
value having to be set.
●
Touching the button again after the
CO
setting will return the appliance to the
40 % setting.
TIMER FUNCTION BUTTON
●
The timer function is deactivated in the standard setting
00h
.
●
Once you touch the
button,
01h
lights up for one hour. Each touch of the
button increases the value by one hour until a maximum of 12 hours is reached.
After that,
00h
lights up in the display and the timer is deactivated again.
●
When the desired humidification time resp. the set hours have elapsed, the
appliance switches off without a sound signal.
NIGHT MODE BUTTON
●
With this button, you can activate the night mode, meaning that the appliance
switches to slow ventilation speed
SL
while all the other settings stay intact.
However, there is no sound signal when the water shortage alarm is sounded,
the display merely states
NO!
in alternation with the three bars
■
■
■
■■
. Like that,
nobody will be woken up by the appliance. If you have activated night mode,
only the night mode button and the ON/OFF button can be operated, all the
other buttons are locked.
●
If you wish to activate night mode, touch the
button.
ZZZ
flashes five times
in the display, then the display is dimmed down before going dark completely.
●
If you wish to deactivate night mode, touch the
button again,
ZZZ
flashes
three times in the display and the appliance switches back to the most recent
settings. The display lights up normally.
“WATER SHORTAGE“ DISPLAY
●
Once you activate the appliance, the Airwasher checks if there is enough water
in the water tub. Should this not be the case, it automatically switches to the
water shortage safety function. This is also the case if the appliance runs dry
during use, in this case, the appliance switches to water shortage safety function
within 6 seconds.
●
In the water shortage safety function, the main motor switches off. The display
states
NO!
in alternation with
■
■
■
■■
. Simultaneously, sound signals can be
heard, again after 30 seconds and again after further 30 seconds. Then, the
appliance switches to standby mode, the display goes out.
●
In the water shortage safety function, only the ON/OFF button
;
can be ope-
rated.
FILLING WATER INTO THE WATER TANK
●
Switch the appliance off with the ON / OFF button
;
. Carefully remove the upper
appliance backside with the handhold by first tilting it outwards at the top and
then lifting it up and away. Turn the water tank upside down, open the tank
lid and fill the water tank with fresh tap water. Then, close the tank with the lid
and lock the tank back into the appliance.
