Installation
Set up Solisto.Home in two steps: plug in all relevant cables and set up the remote
control. All connections are made at the back of the device.
First connect the analogue output
2
of the Solisto.Home with the analogue input of
your hi-fi system or similar device. You can use either the cinch cable that comes
with your Solisto.Home or any other usual connection cable. The AC adaptor is
plugged into connector
3
. The USB connection
1
supports almost any USB device.
USB extension cables of up to 5 metres in length may be used.
If you wish to use the Solisto.Home remote control, it can now be switched on by
pressing the push-button
4
to play music for the first time. Then refer to section
concerning operation of the Solisto.Home
Controlling the Solisto.Home with other
remote controls.
Example diagram of how to connect the Solisto.Home to a hi-fi system:
1.
USB connector
2.
RCA/cinch analogue
output connectors
3.
Connector for AC adaptor
4.
Push-button to switch
standby mode on and off.
1
2
3
4