R
Solmeta geotagger
Pro
11
Firmware upgrade
The procedure of firmware upgrade is as below:
1. Turn Off the Pro device.
2. Connect the device to a computer with the USB cable provided.(Please make sure the USB driver has
been
installed in your computer)
3. Hold the
button, short press the Power button, the backlight will be on, then release both the
MENU
MENU
and the Power button together.
4. Running the “Solmeta Utility(V2.0)” in your computer. (Please make sure the application is the latest
version which can be downloaded from our website)
5. Click the “Firmware Update” button, then the interface of Firmware upgrade will pop up.
6. Click the “Browse” button to select the .bin file of the latest firmware version.
7. Click the “Download Update” button to perform the firmware upgrade.
Note
1. The operation of " firmware upgrade" will cause the loss of program information stored. A data back up to
your computer is strongly recommended before you perform the operation of "firmware upgrade".
2. Once the "firmware upgrade" completed, please reset the system to “factory default”. To perform the
setting, see the section
in page7.
Operation Tips
3. Please do the compass calibration if necessary.(Please refer to the compass calibration in
page 14)