ENGLISH
9
The red clip can be used to secure the shut-off
valve in its rest position to prevent accidental
spraying. For this, pull the lever slightly away (a)
from the handle and lock the clip (b).
4.2 Residual spraying agents /
finishing spraying
Switch off the pump immediately when any air is
sucked in and sprayed out through the spray
nozzle. This is indicated by a mist being sprayed
from the nozzle. At this point the spraying agent
tank will still contain a residual amount of less than
200 ml [6.8 oz]. If you do not want to fill in any
more spraying agent and want to end spraying,
collect and dispose of the remaining amount
according to the applicable laws and provisions.
Observe the information from the spraying agent
manufacturer.
When you finish working, prepare the device for
storage according to section 5.3, thoroughly wash
your face and hands with soap, take off your work
clothing and ensure that it is washed regularly.
5 Maintenance, cleaning and storage
5.1 Greasing the cap gasket
If the tank lid becomes hard to tighten or open,
apply silicone grease to the lid gasket.
5.2 Greasing the piston collar and the pump
piston pump
After disassembly of the pump components or after
replacing the piston collar, use water resistant
grease to lubricate the piston and the collar.
5.3 Draining the spraying agent tank and
cleaning all other spraying agent carrying
parts
Drain the spraying agent tank, all other spraying
agent carrying parts and the filling strainer daily
after use and thoroughly flush them with clean
water.
Any unused spraying agent that is left over in the
device could cause corrosion and hence damage
the device. Special attention must be paid to
wearing parts like spray nozzles, filters and seals.
Please read and observe the cleaning instructions
supplied with the spraying agent.
Never use aggressive, acid- or solvent-containing
cleaning agents (gasoline for example).
After cleaning, leave the spraying agent tank open
to dry.
Cleaning the spray nozzle and the filling strainer:
To depressurise the device, hold the spray tube
in the spraying agent tank or in a suitable
container for the spraying agent and operate the
shut-off valve until no more fluid is sprayed.
Rinse the nozzle attachment with clean water.
Disassemble the nozzle attachment .
Clean the O-rings, the spray nozzle and the
filling strainer with clean water and a soft brush.
Never use your mouth to blow through the spray
nozzle! Never use hard objects to clean the
nozzles!
Reassemble the components of the nozzle
attachment (Fig. 2).
5.4 Taking the sprayer out of service and
putting it into storage
Prepare the device for storage according to
section 6.7.
Store the device protected from sunlight in a
secure, dry and frost-free location under a
maximum ambient temperature of 35 °C [95 °F].
There must not be any open fires or similar
nearby.
Ensure that the unit cannot be used by
unauthorised persons, in particular children.
Fig. 12
Fig. 13
