5. WARNING:
A certified Personal Floatation Device (PFD) is required for each passenger. It is especially
important that children and non-swimmers wear a Personal Floatation Device at all times.
Children and non-swimmers need special instruction in the use of the Personal Floatation Device.
6. WARNING:
Use caution when stepping or climbing aboard the boat. Step into the center of the boat
for maximum stability. Distribute the weight of load and accessories evenly so that the boat sits level
fore to aft and side to side.
7. WARNING:
Do not use your boat if you suspect a puncture or leak. It may be unsafe.
8. WARNING:
Beware of offshore winds and currents.
9. WARNING:
The total number of persons and total weight shall not exceed the information printed on
the boat. Do not exceed the maximum recommended capacities. Overloading violates regulations.
10. WARNING:
It is the responsibility of the boat owner to identify and obey all local and state laws
pertaining to boat safety PRIOR to use. Please consult your local authorities to ensure compliance.
11
Do not allow unattended children in the boat. Always make sure that at least one responsible adult is
supervising all children and those who do not know how to swim
AT ALL TIMES.
12. Always maintain the proper boat safety equipment.
13. Your boat is designed to be a storable, seasonal boat. If the boat will not be in use year-round, it is
STRONGLY RECOMMENDED
that you deflate the boat. Dry it thoroughly and store it in a protected
area for the off-season. This will help extend your boat's life and prevent a safety hazard from
developing while the boat is not in use.
14. WARNING:
Certain household cleaning solvents, chemicals and other liquids (such as battery acid,
oil and gasoline) could damage the PVC fabric. In the event of spill or mishandling, you should check
for leaks and inspect for structural integrity. Use a mild soap to clean the boat; rinse thoroughly.
Do not use MEK, acetone, or other harsh chemicals for cleaning.
ASSEMBLY
1 Find a flat area and make sure that the area you have selected to set up the boat is completely free of
stones, sticks, sharp objects or other foreign debris.
2. Carefully unfold the boat, spreading out the tubes and floor to make them as smooth as possible.
NOTE:
For ease of assembly, it is preferable to set up the boat on a warm and sunny day. If time permits,
expose the unrolled boat to direct sunlight for 1 hour or more, so that the boat material will be more
flexible during assembly.
CAUTION: DO NOT DRAG THE BOAT ACROSS THE GROUND AS IT MAY
TEAR THE BOAT OR CAUSE OTHER DAMAGE.
We will not be held responsible for damage caused to
the boat due to mishandling or failure to follow these instructions.
3.
Inflate the boat's chambers in this order:
1)
main outer tube,
2)
inner main tube,
3)
floor,
4) hull stabilizer tubes. It is very important to follow the sequence: Failure to do so will result in an
improperly inflated boat. You can use a hand or foot-operated air pump to inflate the boat.
Do not use high-pressure air compressors. Inflate each air chamber in the number sequence until all
chambers are full.
WARNING:
Do not over inflate. Maximum pressure for air chambers is 0.75 psi.
Operating Instructions
Preparation before departing:
1. Acquire necessary information and inform other passengers:
A. Get information on local laws, regulation and hazards related to water activities and boat operation.
B. Check weather forecast, local currents, tides and wind conditions.
C. Make a Float Plan: Advise someone on land of your plan and expected return time.
D. Explain basic boat operation to all passengers.
E. Be sure that at least one of your passengers can operate the boat in case of emergency.
F. Learn how to determine the distance you can cover, and remember that bad weather
conditions can alter this.
2. Check the working condition of the boat and equipment:
A. Check inflation pressure.
B. Inspect all safety valves.
C. Check that the load is evenly distributed on deck of the boat; fore to aft and side to side.
D. Only the recommended maximum motor horse power can be safely used for your Solstice boat.
Use of a higher horse power motor can be dangerous and can also result in damage to the boat
(voiding any warranty).
3. Check that required safety equipment is on board (check the laws and regulations of the country or
locality in which you are boating):
A. One personal floatation device (PFD) for each passenger.
B. The air pump, oars, and repair kit.
C. The boat papers and your boating license (if applicable).
D. Lights are required if operating after dark.
Disassembly
1. Remove all accessories (seats, oars, motor mount, etc.).
2. Clean and dry the boat as previously instructed.
3. Open all valves and deflate boat completely. Pinch and hold the open push-in valves. Or, a straw, stirrer
stick or any other non-sharp item can be inserted in the push-in valves to aid in deflation.
4. Fold the boat. Fold port and starboard sides in towards middle. Fold the boat from bow to stern.
Trouble Shooting
• If your boat appears to have lost air, first check that all valves are tightly shut. Note: if the temperature has
cooled or you have been operating in waters colder than ambient temperature (as stated above); this may
cause the pressure to decrease. If either of these has occurred, add air to return the boat to nominal pressure.
• If you suspect a leak, visually inspect the boat. Some punctures are obvious. If you cannot easily detect any
leaks, apply mildly soapy water around the boat and valve areas. Any leak will produce bubbles.
