7
ASSEMBLY OF BASE AND COLUMN UNIT
Before you begin, decide whether you want to set up your
fan as a standing or table fan.
•
For standing fan, you will need to assemble
the Fan using the Fan Pole (4).
•
For table fan, you will need to assemble
the Fan using the Fan Connector (5).
1. Aligning either the Fan Pole (4) or the Fan Connector
(5) to the groove on the Base (6) and tighten them
together using the Right-angled Screw (7).
2. Place the Motor (1) and Casing (2) on top of the Fan
Pole (4) or Fan Connector (5) and fix them together
using the Tightening screw (3).
3. Align the Rear Grill (8) to the Motor (1) grooves and fix
together by tightening the Grill Lock Nut (9) clockwise.
4. Insert the Fan Blade (10) over the Grill Lock Nut (9) and
then screw the Blade Lock Nut (11) anti-clockwise to
secure the fan in place. Manually rotate the Fan Blade
(10) after installing into place to ensure that it will spin
normally during operation.
5. Attach the Front Grill (12) to the Rear Grill (8) aligning
the catch shown below.
6. Press the guards together sequentially with both hands
in the order shown below.
7. Lastly, fasten the Front Grill (12) to the Rear Grill (8)
by using the Guard Catch.
HEIGHT ADJUSTMENT
If the fan is set up as a standing fan (with the Fan Pole (4)
in use), loosen the Height Adjustment Ring (13), turning
it anti-clockwise, before securing it at the desired height
tightening the Ring clockwise.
Assembly Instructions