Attach the remote control receiver
mounting plate to the press board on
the motor ,align the two holes and
tighten the 2 screws provided.
4
Remove screws from motor bracket
and mounting plate. Hang fan from
mounting plate by inserting "T"-shaped
end of bracket into slot opening of
mounting plate. This will allow for
hands free wiring.
Press Board
Mounting
Plate
MOUNTING INSTALLATION
Please refer to page 8~9 for remote controller
and receiver installation and operation detail.
1.
2.
3.
Place the remote control receiver on
the plate and connect wire and then
pull all wires STRAIGHT and TIE them
well with provided plastic cable (in
screw pack) to prevent motor rotating
damage wire and avoid risk of short
cut.